RDS8000 8 CH 2.4G Crawler Radio Surface (2 Stick) by Airtronics

The RDS8000 8-Channel 2.4GHz FHSS-1 Crawler Version radio control system has been designed to allow maximum flexibility for four wheel steering (4WS as well as dig/independent motor control for crawlers with individual front and rear motors). The transmitter comes setup in Mode 1 and both control sticks are spring-loaded. This, coupled with the transmitter's extensive programmable mixes, allows you to customize the transmitter for just about any crawling setup you prefer.

*The RDS8000 Crawler Version retains all of the great features and programming ability of the RDS8000 aircraft version. The only difference is the Crawler version is set up for Mode 1 operation and both control sticks are self-centering. For information about programming the various mixes to control a common Rock Crawler setup, download the Crawler Version Supplement PDF above.

Features

• 8-Channel 2.4GHz FHSS-1 Digital Proportional Computer Radio Control System
• Includes 92824 8-Channel 2.4GHz FHSS-1 Receiver
• Left and Right Control Sticks Spring Loaded (No Ratchets)
• Model Type Selection
• 10 Model Memory
• Model Naming (3 Characters)
• Data Reset and Data Copy
• Stop Watch
• Digital Trims
• Servo Reversing
• End Point Adjustment
• Servo Sub-Trim
• 2 Compensation Mixers
• LCD with Voltage Indicator and Low Voltage Alarm
• Integral System Timer
• Click Audio Tones
• Dual Rate Alarm
• Adjustable Stick Tension and Length
• Switch Reversing
• 8 Cell Ni-Cd Transmitter Battery
• Trainer System

Aircraft-Specific Programming Features:

• Exponential
• Dual Rate (Elevator and Aileron)
• Digital Trim Memory • Trim Authority (STEP) for Digital Trim
• Flaperon and Spoileron Mixing
• Elevon (Delta) Mixing
• V-Tail Mixing
• Throttle Cut
• Dual Elevator Mixing
• Aileron Mixing
• Landing Differential
• Crow Mixing
• Flap to Elevator Mixing, Throttle to Elevator Mixing and Rudder to Aileron Mixing
• Aileron to Rudder Mixing, Rudder to Elevator Mixing and Elevator to Flap Mixing

Helicopter-Specific Programming Features:

• Exponential
• Dual Rate (Elevator, Aileron and Rudder)
• Four Flight Modes
• 5-Point Throttle Curve (All Flight Modes)
• 5-Point Pitch Curve (All Flight Modes)
• 3-Point Revo Mixing (All Flight Modes)
• Remote Gyro Control
• Throttle Cut
• Swash Plate Type Selection

What's In The Box:

• RDS8000 8-Channel 2.4GHz FHSS-1 Transmitter
• 92824 8-Channel 2.4GHz FHSS-1 Receiver
• 8 Cell Ni-Cd Transmitter Battery Pack
• AC Dual Output Overnight Charger
• On/Off Switch
• User's Guide

Items Required, But Not Included:

Receiver Battery: The receiver's Nominal Input Voltage is 4.8v ~ 6.6v therefore, the receiver can be powered using a 4 Cell or 5 Cell Ni-Cd or Ni-MH battery pack or a 2S Li-Fe/A123 battery pack. DO NOT USE A 2S Li-Po!

Servos: No servos are included. Analog or Digital servos can be used. We recommend using Airtronics servos that are within the specification range required for your model.

Transmitter Specifications
• Output Power: 90mW
• Current Drain: 180mA
• Temperature Range: 0ºF ~ 160ºF
• Pulse Width: 1.5msec
• Weight with Batteries: 27.0oz (765gr)
• Frequency/Modulation Type: 2.4GHz/FHSS-1

92824 Receiver Specifications
• Frequency/Modulation Type: 2.4GHz/FHSS-1
• Nominal Input Voltage: 4.8v ~ 6.6v
• Weight: 0.33oz (9.0gr) with Case
• Dimensions: 1.85 x 1.08 x 0.60in (47 x 27.5 x 15.2mm)
• Fail Safe Support: Yes (CH 1 ~ CH 4)
• Connector Type: Universal 'Z'